In this article, an attempt is made to prepare tungsten heavy alloy (WHA) powder by high energy ball milling of 95 wt% W, 3.5 wt% Ni and 1.5 wt% Fe in a dual drive planetary ball mill (DDPBM). The present study mainly focusses on the effect of milling on density, microstructure and mechanical properties of sintered WHAs. The minimum crystallite size of 18 nm was observed in 15 h milled WHA powder. Sintering of WHAs was carried out at 1500 degrees C for 1 h in hydrogen atmosphere. The sintered samples prepared from un-milled and ball milled WHA powders were characterized for microstructure (SEM equipped with EDS) and mechanical properties (Rockwell hardness and nanoindentation). The internal attributes and uniformity in distribution of W spheroids'in sintered WHA were investigated with X-ray microcomputed tomography (X-ray mu-CT). All sintered samples exhibited sintered density in the range of 97.1 to 98.6% theoretical. Uniform distribution of W spheroids in Ni-Fe matrix was observed in sintered samples. The mean grain size of sintered WHAs varies in the range of 22.7-31.1 mu m and W-W contiguity (C-ww) ranges from 0.58-0.69. Despite relatively less density (97.1%), the sintered WHA prepared from 15 h milled powder offered good combination of bulk hardness similar to 64.8 HRA and elastic modulus similar to 431 GPa.
Copyright:Copyright [2017]. All efforts have been made to respect the copyright to the best of our knowledge. Inadvertent omissions, if brought to our notice, stand for correction and withdrawal of document from this repository.